Knife Loop Yak 3D Aerobatic Profile ARF Instruction Manual Warranty Merlin Hobbies (www.merlinhobbies.com) guarantees this kit to be free from
10Done. Install the Control Surfaces and Rudder Most of the control surfaces have been pre slotted. If you find that hinge strips do not go in
11 Connect the Control Horns Carefully select the mounting area for each control horn. The horn should be in line with the control r
12 Use hook and loop material to hold the battery on the other side of the fuselage as shown below. This will help with balancing. Bal
13 Range Check At the field, ensure that your radio channel is not occupied and that it is safe to turn on your radio. Apply power to your radio
2Safety precautions Be aware that this model is a sophisticated working model that functions much like a real aircraft. Correct assembly and ope
3CA Accelerator 30 Minute Epoxy Hobby Knife and blades Builders Triangle Masking Tape Electric Power Drill Pliers Filament used for alignment pur
4 Mount the Wing Slide the unassembled wing into the opening in the fuselage. Locate the wing at its center and carefully mark th
5Mount the Stab Trim open the stab opening. Adjust the stab in position until you are satisfied that it is square. Using a felt tip pen, m
6 Next, align the center opening of the smooth rectangular plate, to the center opening of the rounded plate you just assembled. Glue both p
7Trim the airframe of the model as shown below. This will allow the finished assembly to slide into position. Test fit the motor mou
8 Remove the sleeve and put it aside, the motor mount you have just built will replace the lock. Slip the motor shaft through the c
9 This is how the final assembly looks with the prop adapter and prop mounted. Slide the mount into the airframe and use the small predrilled
Comments to this Manuals